Which cisco ios switch command is used to configure the use of lacp on an interface?

Ge-2/0/1 Partner No No Yes Yes Yes Yes Fast Active Ge-2/0/1 Actor No No Yes Yes Yes Yes Fast Active Ge-2/0/0 Partner No No Yes Yes Yes Yes Fast Active Ge-2/0/0 Actor No No Yes Yes Yes Yes Fast Active LACP state: Role Exp Def Dist Col Syn Aggr Timeout Activity [edit commitДЇrom operational mode, enter the show lacp interfaces If you are done configuring the device, commit the configuration. [edit set interfaces ae0 unit 0 family ethernet-switching vlan members vlan1000 [edit set vlan vlan1000 vlan-id 1000ДЄdd the ae0 interface to the VLAN. [edit set interfaces ae0 unit 0 family ethernet-switching interface-mode trunkД¬onfigure the VLAN. [edit set interfaces ae0 aggregated-ether-options lacp active periodic fastД¬onfigure ae0 as a trunk port. [edit set interfaces ae0 vlan-taggingД¬onfigure LACP for ae0 and configure periodic transmission [edit set interfaces ge-0/0/6 ether-options 802.3ad set interfaces ge-0/0/7 ether-options 802.3ad ae0Д¬onfigure ae0 interface for vlan tagging. For instructions on how toДo that, see Using the CLI Editor in Configuration Mode in the CLI User Guide.Д¬onfigure the interfaces for ae0. The following example requires you to navigate various The interval can be fast (every second) or slow (every 30 seconds). That is, the remote side transmits link aggregationД¬ontrol PDUs at the specified interval. It is the configuration on the local side that specifies the behavior The periodic statement on the interfaces on the local side. Side of the link transmit link aggregation control PDUs by configuring You configure the interval at which the interfaces on the remote Passive interfaces at different rates, the transmitter honors the You can configure different periodic rates When they receive them from the remote end of the same link.Д«y default, the actor and partner transmit link aggregationД¬ontrol PDUs every second. Transmission mode, links send out link aggregation control PDUs only Passive mode, they do not exchange link aggregation control PDUs.ДЄs a result, the aggregated Ethernet links do not come up. Passive mode-If the actor and partner are both in The actor knows about its own state and that of the partnerвЂ™s The actor sends linkДЄggregation control PDUs to its protocol partner that convey what They exchange link aggregation control PDUs. The transmission of link aggregation control protocol data units (PDUs)ДЄnd response link aggregation control PDUs, you must enable LACP atД«oth the local and remote ends of the links, and one end must be active:ДЄctive mode-If either the actor or partner is active, Setting the mode to either passive or active. LACP is enabled on an aggregated Ethernet interface by The remote end of the link is known as the partner.

Within LACP, the local end of a child link is known as the actor and Means for exchanging information between partner systems on a link. Link Aggregation Control Protocol (LACP) provides a standardized

Which cisco ios switch command is used to configure the use of lacp on an interface?